Use of Commands

The commands used in Look RS232 are shown in assistant:

This version has the following commands:

set control signal commands

format selection commands

macro use command

file transmission commands

There tow ways to enter a command:

• enter the first letter of command name to activate it. 

• if assistant is enabled, press SpaceBar in an empty line or after a coma, select a command from the suggested list. 

If Use Short Commands option located in Task Editor is disabled, after the first letter of a command is entered, its full name will be displayed in a line automatically.

You can enter several commands in one line, just note to separate them with comas.